You are here

PuTTY: Tunnels not saving

6 posts / 0 new
Last post
erunaheru
Offline
Last seen: 4 years 3 weeks ago
Joined: 2008-09-10 10:09
PuTTY: Tunnels not saving

Tunnels that I create show up in the window, but when a session is opened they have no effect, and when I restart the program they are gone. If I run putty.exe instead of puttyportable.exe (and leave permanent registry entries), it works.

erunaheru
Offline
Last seen: 4 years 3 weeks ago
Joined: 2008-09-10 10:09
Oh, and by the way, my

Oh, and by the way, my sessions save fine, just not the tunnels.

erunaheru
Offline
Last seen: 4 years 3 weeks ago
Joined: 2008-09-10 10:09
Work around

Figured out how to work around this using command line options, but I am still curious as to what the problem actually is.

USBman
Offline
Last seen: 2 years 6 months ago
Joined: 2006-10-11 17:43
Work around?

Can you share what your work around was?

erunaheru
Offline
Last seen: 4 years 3 weeks ago
Joined: 2008-09-10 10:09
At a command prompt

PuTTYPortable.exe -L [local port]:[remote address]:[remote port] -load [session] -l [remote login] -pw [remote password]

for example to forward port 8080 on the local computer to port 80 on the remote computer: -L 8080:127.0.0.1:80

or to forward 8080 on the local computer to port 80 on a computer with IP 192.168.1.1 that is accessible to the remote computer: -L 8080:192.168.1.1:80

and if you don't like putting your login or password in at the prompt, just leave them off and it will ask for them normally.

OctavioShaffer
Offline
Last seen: 5 years 12 months ago
Joined: 2018-11-13 07:18
I could open the data using

I could open the data using Use File > Data Input > AcuSolve Direct Reader, but I cannot see the streamlines. How can I do it? I have tried until now so many ways and unfortunately nothing happens and open my ip address 192.168.1.1.

The simulation is ok, I obtained the vwtAnalysis.pdf with the Drag coefficient, Lift coefficient, etc.

Could you please explain step by step what I should do?

yes baby

Log in or register to post comments